A fully updated 2021 CQE Exam Dumps exam guide from training expert PassSureExam
Provides complete coverage of every objective on exam and exam preparation CQE
NEW QUESTION 33
Of the services listed below, which one performed by design engineering is of particular interest to QA personnel?
- A. Audit reports.
- B. Change action.
- C. Cost reports.
- D. Rework criteria.
Answer: B
NEW QUESTION 34
As a commonly used problem solving technique, which of the following would be the BEST application of a Pareto chart?
I. To determine when to make proactive adjustments to a process.
II. To differentiate between major and minor problem areas.
III. To gather data and to design experimental controlled changes.
IV. To evaluate the results of other problem solving techniques upon the product or service.
- A. II and IV only
- B. I and II only
- C. I, II, III and IV
- D. II and III only
Answer: A
NEW QUESTION 35
A purchase order for subassemblies classified as critical must include a review by
. Quality engineering.
. The procurement department.
. Design engineering.
- A. I andIIIonly
- B. IIandIIIonly
- C. I,IIandIII
- D. IIIonly
Answer: C
NEW QUESTION 36
In nonparametric statistics:
I. No assumptions are made concerning the distribution from which the samples are taken.
II. The parameters of the distribution do not relate to the parameters of the sample.
III. The sample and the distribution must have no parameters in common.
- A. I only
- B. II only
- C. III only
- D. II and III only
Answer: A
NEW QUESTION 37
Reliability prediction is
I. The process of performance estimation.
II. The process of estimating the probability that a product will perform its intended function for a stated time.
III. The process of telling "how you can get there from here".
- A. I only
- B. I, II and III
- C. II only
- D. II and III only
Answer: C
NEW QUESTION 38
In the failure rate model shown below, which one of the sections represents the period when catastrophic failures are likely to occur?
- A. B
- B. C
- C. All sections can experience catastrophic failure.
- D. A
Answer: C
NEW QUESTION 39
Which of the following distributions have the set of all real numbers as their domain?
- A. None of the above.
- B. Lognormal
- C. Weibull
- D. Exponential
Answer: A
NEW QUESTION 40
A process is turning out end items that have defects of type A or type B or both. If the probability of type A defect is 0.1 and of a type B is 0.2, the probability that an end item will have no defect is
- A. 0.30
- B. 0.68
- C. 0.7
- D. 0.72
Answer: D
NEW QUESTION 41
In most cases, an improvement team facilitator will NOT normally:
- A. Provide feedback to the group.
- B. Summarize key ideas generated by the group.
- C. Be familiar with problem solving techniques.
- D. Function as the group leader.
Answer: D
NEW QUESTION 42
Select the incorrect statement from among the following. The IDs of a certain piece of tubing are normally distributed with mean 1.00". The proportion of tubing with IDs less than 0.90 is
- A. Less than 50 percent.
- B. Less than the proportion with IDs greater than 1.10
- C. Less than the proportion of Ids greater than 0.90
- D. Less than the proportion with IDs greater than 1.00
Answer: B
NEW QUESTION 43
The "least squares method" is used in
- A. Calculating a best fit regression line.
- B. The central limit theorem
- C. Calculating2and s2
- D. Calculating 2
Answer: A
NEW QUESTION 44
A product failure in the customer's hands is bad for the company. Why do only 4% of the customers normally file a complaint?
- A. A warranty is in place on the product.
- B. The product guarantee takes care of the product.
- C. They don't think it will do any good.
- D. It is a minor inconvenience.
Answer: C
NEW QUESTION 45
An operation requires shipments from your vendor of small lots of fixed size. The attribute sampling plan used for receiving inspection should have its OC curve developed using
- A. The Poisson distribution.
- B. The Gaussian (normal) distribution.
- C. The hypergeometric distribution.
- D. The binomial distribution.
Answer: C
NEW QUESTION 46
A comprehensive corrective action program is initiated at a large company. Input for CARs are received from customers, internal and external audits, material review reports and other sources. Which two of the following groups would usually administer and control the CAR process?
I. Management review team.
II. Quality department.
III. Corrective Action Board.
IV. Material Review Board.
- A. I and III only
- B. III and IV only
- C. I and II only
- D. II and III only
Answer: A
NEW QUESTION 47
Which of the following distributions have the set of all real numbers as their domain?
- A. None of the above.
- B. Lognormal
- C. Weibull
- D. Exponential
Answer: A
NEW QUESTION 48
An X-bar and R chart with n=5 has been plotted for some time and has demonstrated random variation. Upon review of the last 30 plot points, the expected number of runs around the centerline on the X-bar chart is expected to be approximately which of the following?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION 49
......
Tested Material Used To CQE: https://www.passsureexam.com/CQE-pass4sure-exam-dumps.html
Steps Necessary To Pass The CQE Exam: https://drive.google.com/open?id=1ygblYOmcVAKGDDmDmDGMs-_l4HhQaWyy