[Jan-2022] Latest Cisco 300-815 exam dumps and online Test Engine
Cisco 300-815: Selling CCNP Collaboration Products and Solutions
Introduction to Cisco 300-815: Implementing Cisco Advanced Call Control and Mobility Services Exam
Implementing Cisco Advanced Call Control and Mobility Services v1.0 CLACCM 300-815 is a 90-minute exam associated with the CCNP Collaboration Certification. This exam tests a candidate’s knowledge of advanced call control and mobility services, including signaling and media protocols, CME/SRST gateway technologies, Cisco Unified Board Element, call control and dial planning, Cisco Unified CM Call Control, and mobility. The course, Implementing Cisco Advanced Call Control and Mobility Services, helps candidates to prepare for this exam. In addition, you use the Dynamic Host Configuration Protocol (DHCP) to fix faults, network security, and VLAN settings, as well as many other common network concerns. The chance to acquire new concepts and to improve understanding via a range of integrated lab settings is an essential element of this course. You may resolve your problems by using 300-815 dumps and different laboratory conditions in a wide range of case studies.
Cisco 300-815 Exam Certification Details:
| Passing Score | Variable (750-850 / 1000 Approx.) |
| Exam Registration | PEARSON VUE |
| Exam Name | Implementing Cisco Advanced Call Control and Mobility Services |
| Duration | 90 minutes |
| Exam Code | 300-815 CLACCM |
| Recommended Training | Implementing Cisco Advanced Call Control and Mobility Services (CLACCM) |
| Number of Questions | 55-65 |
| Sample Questions | Cisco 300-815 Sample Questions |
| Exam Price | $300 USD |
NEW QUESTION 67
Refer to the exhibit.
Calls incoming from the provider are not working through newly set up Cisco Unified Border Element. Provider engineers get the 404 Not Found SIP message. Incoming calls are coming from the provider with called number "222333444" and Cisco Unified Communications Manager is expecting the called number to be delivered as "444333222". The administrator already verified that the IP address of the Cisco Unified CM is set up correctly and there are no dial peers configured other than those shown in the exhibit. Which action must the administrator take to fix the issue?
- A. Create specific matching for "222333444" on the incoming dial peer.
- B. Set up translation-profile on the incoming dial peer to match incoming traffic.
- C. Change the destination-pattern on the outgoing dial peer to match "444333222".
- D. Fix the voice translation-rule to match specifically number "222333444" and change it to "444333222".
Answer: B
NEW QUESTION 68 
Refer to the exhibit. In an active SIP call between phone user A and phone user B, phone A initiates a call transfer to phone user
C. Which two scenarios are correct? (Choose two.)
- A. Phone_B sends a SIP-REFER message to the Cisco Unified CM with Phone_C information in the Refer-To section.
- B. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the music on hold and the MOH audio is chosen from Phone_A Network Hold MOH Audio Source settings.
- C. Phone_A sends a SIP-REFER message to the Cisco Unified Communications Manager with Phone_C information in the Refer-To section.
- D. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the MOH and the MOH audio is chosen from Phone_B User Hold MOH Audio Source settings.
- E. As soon as Phone_A presses the Transfer button for the first time, Phone_B hears the MOH and the MOH audio is chosen from Phone_A User Hold MOH Audio Source settings.
Answer: C,D
Explanation:
Section: Signaling and Media Protocols
NEW QUESTION 69
When configuring hunt groups, where do you add the individual directory numbers that will be part of the group?
- A. route group
- B. hunt pilot
- C. line group
- D. hunt list
Answer: C
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_0_1/systemConfig/ cucm_b_system-configuration-guide-1201/cucm_b_system-configuration-guide-1201_chapter_010101.html
NEW QUESTION 70
Refer to the exhibit.
An engineer configures Cisco Unified Border Element to connect the enterprise VoIP network with a SIP telephony provider. Calls are not working in either direction. What must be configured in the dial peer 1 to fix the issue?
- A. answer-address 555 ........
- B. incoming called number 555.......
- C. session-protocol sipv2
- D. codec g729
Answer: C
NEW QUESTION 71
Which description of RTP timestamps or sequence numbers is true?
- A. Timestamps increase by the time "carrying" by a packet.
- B. The timestamp is used to place the incoming audio and video packets in the correct timing order (playout delay compensation).
- C. The sequence number is used to detect losses.
- D. Sequence numbers increase by four for each RTP packet transmitted.
Answer: B
Explanation:
Section: Signaling and Media Protocols
Explanation/Reference: https://www.cs.columbia.edu/~hgs/rtp/faq.html
NEW QUESTION 72
A user reports when they press the services key they do not receive a user ID and password prompt to assign the phone extension. Which action resolves the issue?
- A. Assign the extension as a mobile extension.
- B. Create the end user and associate it to the device profile.
- C. Create the default device profiles for all phone models that are used.
- D. Subscribe the phone to the Cisco Extension Mobility service.
Answer: D
NEW QUESTION 73
What is a component of Cisco Unified Mobility?
- A. Mobile Connect
- B. Smart Client Support
- C. Unified IVR
- D. Single Number Connect
Answer: A
NEW QUESTION 74
Which two extended capabilities must be configured on dial peers for fast start-to-early media scenarios (H.323 to SIP interworking)? (Choose two.)
- A. BFCP
- B. FAX
- C. AUDIO
- D. DTMF
- E. VIDEO
Answer: A,D
NEW QUESTION 75
An administrator is implementing a new dial-plan on Cisco Unified Border Element. The administrator must ensure that incoming dial-peers are matched based on the IP address from where the incoming request originates. Which dial-peer configuration should be applied to accomplish this requirement?
- A. dial-peer voice 1 voip
incoming called-number - B. dial-peer voice 1 voip
incoming url via - C. dial-peer voice 1 voip
incoming url to - D. dial-peer voice 1 voip
incoming url request
Answer: B
NEW QUESTION 76 
Refer to the exhibit. How many maximum hops can an ILS updarte traverse?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
Explanation:
Section: Cisco Unified CM Call Control Features
NEW QUESTION 77
Refer to the exhibit.
How many maximum hops can an ILS update traverse?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 78
An engineer must implement call restriction to toll-free numbers using a class of restriction in a branch Cisco UCME. In which two places is the corlist incoming or cor Incoming command configured? (Choose two.)
- A. "dial-peer cor custom" configuration mode
- B. "telephony-service" configuration mode
- C. "voice register pool" configuration mode
- D. "voice register global" configuration mode
- E. "ephone-dn' configuration mode
Answer: C,E
NEW QUESTION 79
Refer to the exhibit.
An engineer is troubleshooting an issue where inbound calls to Cisco UCM with early media fail to establish. While investigating the issue, the engineer finds that Cisco UCM is set to require a PRACK. but the Cisco Unified Border Element is not sending it. Which command is causing this issue?
- A. voice-class sip rel1xx disable
- B. voice-class sip conn-reuse
- C. voice-class sip early-media update block
- D. voice-class midcall-signaling block
Answer: A
NEW QUESTION 80
Which section under the Real-Time Monitoring Tool allows for reviewing the call flow and signaling for a SIP call in real time?
- A. Voice/Video > Session Trace Log View > Open From Local Disk
- B. Voice/Video > Session Trace Log View > Real Time Data
- C. System > Tools > Trace and Log Central
- D. Analysis Manager > Inventory > Trace File Repositories
Answer: B
NEW QUESTION 81
Which section under the Real-Time Monitoring Tool allows for reviewing the call flow and signaling for a SIP call in real time?
- A. Voice/Video > Session Trace Log View > Open From Local Disk
- B. Voice/Video > Session Trace Log View > Real Time Data
- C. System > Tools > Trace and Log Central
- D. Analysis Manager > Inventory > Trace File Repositories
Answer: B
Explanation:
Reference:
https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications- manager-callmanager/213583-procedure-to-analyse-call-flow-of-sip-ca.html
NEW QUESTION 82
......
What Is 300-815 Exam and Who Is Its Targeted Audience?
This 300-815 Implementing Cisco Advanced Call Control as well as Mobility Services exam checks the applicant's understanding of various advanced level call control as well as mobility features. Particularly, such an exam is intended for those with a firm grasp of various signaling and media protocols, gateway technologies, Cisco Unified Border element, CM Call Control, and other related concepts. As for its details, the exam needs to be finished within 90 minutes. Also, the applicant requires an account on Pearson VUE to schedule the exam. Thus, the candidate should select Proctored Exams and enter 300-815 as the test number on the Pearson VUE website. As you keep in mind, securing a passing score in the Cisco 300-815 test will push the entrant a step closer to earning the CCNP Collaboration endorsement.
New 2022 300-815 Test Tutorial (Updated 120 Questions): https://www.passsureexam.com/300-815-pass4sure-exam-dumps.html
Reliable 300-815 Exam Tips Test Pdf Exam Material: https://drive.google.com/open?id=1m0biP4RD-IuXRslZdP6l3XZu-rC1g8Op